TAZ4 exchange extruder
Jump to navigation
Jump to search
Steps you need to follow when exchanging the extruder on the TAZ 4
Changing to Syringe
- Disconnect extruder
- Remove default extruder
- Flash appropriate firmware for syringe extruder by defining SYRING and undefine E3DV6 in the code.
- Place syringe extruder and connect appropriately
- Set E-Steps. Issue these commands "M92 E8000" and after "M500".
Changing to Default
- Remove syringe extruder
- Flash appropriate firmware for default extruder by undefining SYRING and define E3DV6 in the code.
- Place default extruder and connect appropriately
- Set PID values
- To run PID tuning issue this command "M303 E0 S200 C8"
- Once you have the values set them using this command "M301 P49.22 I5.87 D103.22"
These are the last known PID values for TAZ 4
- Set E-Steps. Issue these commands "M92 E833" and after "M500".